Comparison of Material Standards
| SFS-EN | SFS-EN 1) | SS 1) | DIN 1) | BS 1) | ASTM |
| 10130 | 10130 | 1623 | 1449 | ||
| 2000 | 1991 | ||||
| DC01 | Fe P 01 | 14 11 42 | St 12 | CR 4 | A366 |
| DC03 | Fe P 03 | 14 11 46 | St 13 | CR 3 | A619 |
| DC04 | Fe P 04 | 14 11 47 | St 14 | CR 1 | A620 |
| DC05 | Fe P 05 | – | – | – | – |
| DC06 | Fe P 06 | – | – | – | – |
1) Obsolete, replaced by EN Standards. Original standards must be used in detailed comparison.
Mechanical Qualities
| SFS-EN | SFS-EN 1) | Yield strength | Tensile strength | Elongation at break |
| 10130 | 10130 | Rp0,max.2 | Rm | A80 |
| 2000 | 1991 | N/mm2 | N/mm2 | min % |
| DC01 | Fe P 01 | 280 | 270…410 |
28 |
| DC03 | Fe P 03 | 240 | 270…370 |
34 |
| DC04 | Fe P 04 | 210 | 270…350 |
38 |
| DC05 | Fe P 05 | 180 | 270…330 |
40 |
| DC06 | Fe P 06 | 180 | 270…350 |
38 |
Surface Quality
Regular surface quality is adequate for most applications. Slight surface and color variations are allowed.
Surface quality marked A. Surface quality may be used for demanding surface finishing. The upper surface is practically flawless and has no defects to disrupt uniformity and looks.
The lower surface complies to minimum surface quality demands. Demanding surface quality is only available by sheets. Surface quality is marked B.
Surface finish
| Surface finish | Marked | Ra value |
| Semi-bright | g | Ra ≤ 0,9 µm |
| Matt | m | 0,6 µm < Ra ≤ 1,9 µm |
| Rough | r | Ra > 1,6 µm |